Fanless and Silent | Passive cooling, no fan noise at all Perfect to be used in noise-sensitive environments Fanless, dust-free and thus virtually maintenance-free |
Low Power Consumption | Power consumption: idle: 12.5 W, full load: 17 / 26.5 W (without/with graphics) (measured with 2x 2GB SO-DIMM, 60 GB 2.5" SSD) |
24/7 Nonstop Operation | This device is approved for 24/7 permanent operation. Requirements: - Free circulation of air amongst the PC must be guaranteed. - Ventilation holes must stay clear. - If a hard disk is installed, this must also be approved for permanent operation by its |
Chassis | Slim-PC (Nettop) with black chassis made of steel Without cooling fan, passive cooling only The bays for memory, 2.5" drives and Mini-PCIe cards can be easily accessed by removing two cover plates. Dimensions: 200 x 165 x 39.5 mm (LWH) = 1.3 litres Weight |
Operation Position | 1) Device must only be used in vertical position with the DisplayPort port facing up 2) Please make sure to use either the supplied feet or the VESA mount |
Operation System | This barebone system comes without operating system. It is compatible with Windows 8, Windows 7 and Linux Supports 32- and 64-bit. |
Processor | Model: Intel i7-5500U (ULV) System-on-a-chip architecture (SoC): no chipset required Code name: Broadwell (5th Generation Intel Core) Cores / Threads: 2 / 4 Clock rate: 2.4 GHz, up to 3.0 GHz in Turbo mode L1/L2/L3 Cache: 128 kB / 512 kB / 4096 kB Memory controller: DDR3L-1600 Dual Channel (1.35V) TDP wattage: 15 W maximum Manufacturing process: 14 nm Maximum Tjunction Temperature: 105°C Integrated Intel HD graphics 5500 engine Supports 64 Bit, VT-x, VT-d, AVX, AVX2, AES-NI, Enhanced SpeedStep, NX bit, SSE 4.1/4.2 |
Integrated Graphics | Intel HD graphics 5500 Two digital audio/video ports: DisplayPort 1.2 [7] and HDMI 1.4a Clock rate: 300~950 MHz Execution Units (EU): 24 Supports one Ultra HD / 4K display running at 3840 x 2160 (2160p) resolution Max. frame rate with Ultra HD resolution: 60 Hz via DisplayPort, 30 Hz via HDMI Supports two independent screens at 2560 x 1600 resolution Supports DirectX 11.2, OpenCL 1.3/2.0, OpenGL 4.3 Supports full AVC/VC1/MPEG2 hardware decoding Supports HD video plus multi-channel digital audio via a single cable Dynamic, shared memory: up to 1632 MB |
Mainboard / BIOS | Shuttle Mainboard FS57 All capacitors are high quality solid capacitors Supports resume after power failure Supports Wake on LAN (WOL) Supports Power on by RTC Alarm Supports boot from USB devices and SD card reader AMI BIOS in 8 MByte EEPROM with SPI int |
Power Adapter | External 65 W power adapter (fanless) Input: 100~240 V AC, 50/60 Hz, max. 1.6 A Output: 19 V DC, max. 3.42 A, max. 65 W DC Connector: 5.5/2.5mm (outer/inner diameter) |
Memory support | 2x SO-DIMM slots with 204 pins Supports DDR3L-1333 (PC3-10600) and DDR3L-1600 (PC3-12800) SDRAM at 1.35V Supports Dual Channel mode Supports a maximum of 8 GB per DIMM, maximum total size: 16 GB Supports two unbuffered DIMM modules (no ECC) Caution: This |
Mini PCIe Slots | Two Mini PCI Express expansion slots: full size and half size 1) the half size slot is occupied by a WLAN module 2) the full size slot supports PCIe 2.0, SATA 3G and USB 2.0 and can either be used for a Mini-PCIe card or for a Mini SATA (mSATA) flash memo |
Audio | Audio Realtek® ALC 662 High-Definition Audio Two analog audio connectors (3.5mm) at the back panel: 1) 2 channel line out (head phone) 2) microphone input Digital multi-channel audio output: via HDMI and DisplayPort |
Dual Gigabit LAN | Dual network with two RJ45 ports Used network chips: 1) Intel i211 Ethernet Controller with MAC, PHY and PCIe interface 2) Intel i218LM PHY connected to the MAC of the processor Supports 10 / 100 / 1.000 MBit/s operation Supports WAKE ON LAN (WOL) Support |
Wireless Network (WLAN) | Built-in Mini-PCIe WLAN card (half size) and internal antenna Single-Chip 1T1R WLAN Controller Realtek RTL8188EE Supports IEEE 802.11b/g/n, max. 150Mbps up-/downstream Security: WPA/WPA2(-PSK), WEP 64/128bit, IEEE 802.11x/i |
2.5 Drive Bay | Supports one Serial ATA hard disk or one SATA SSD drive in 6.35cm/2.5" format Device height: 9.5 or 12.5 mm (max.) Supports Serial-ATA III, 6 Gb/s (600 MB/s) bandwidth Supports Unified Extensible Firmware Interface (UEFI) Note: no Serial ATA cable is requ |
Card Reader | Integrated SD card reader Supports SD, SDHC and SDXC memory flash cards Supports booting from SD card |
Front Panel connectors | 4x USB 2.0 2x RS232 serial ports (5V/12V, 1x switchable to RS422 / RS485) covered with black plastic caps SD card reader (supports SD, SDHC, SDXC) Power button Power LED (blue) HDD LED (yellow) |
Back Panel connectors | DisplayPort 1.2 HDMI 1.4a 2x USB 3.0 2x Gigabit LAN (RJ45) Microphone input Audio Line-out (headphone) DC-input connector for external power adapter 4-pin connector "SW2" (2.54 mm pitch) for power button, Clear CMOS and 5V DC Perforation for optional Wir |
Onboard connector | EDP1 - Embedded DisplayPort (eDP, 2x15 pin) |
Always-On Jumper | By removing Jumper J7 (please refer to the quick user guide) the system will start unconditionally once power is applied. |
Scope of Delivery | Multi-language user guide Two metal feet with four screws M3 x 7 VESA mount for 75/100mm standard (two metal brackets) Four thumbscrews M3 x 5 mm (screws together VESA mount and PC) Four screws M4 x 10 mm (to fix the VESA mount to the external surface) Ra |
Environmental Specifications | Operating temperature range: 0~40 °C Relative humidity, non-condensing: 10~90% |
Conformity/Certifications | EMI: FCC, CE, BSMI, C-Tick Safety: CB, BSMI, ETL This device is classed as a technical information equipment (ITE) in class B and is intended for use in living room and office. The CE-mark approves the conformity by the EU-guidelines: - EMV-guideline 89 |