Características técnicas
Especificaciones sujetas a cambio por parte del fabricante.
| Fanless and Silent | Passive cooling, no fan noise at all Perfect to be used in noise-sensitive environments Fanless, dust-free and thus virtually maintenance-free |
| Low Power Consumption | Power consumption in idle mode under Windows 10: ca. 7~8 W only |
| 24/7 Nonstop Operation | This device is approved for 24/7 permanent operation. Requirements: - Free circulation of air amongst the PC must be guaranteed. - Ventilation holes must stay clear. - If a hard disk is installed, this must also be approved for permanent operation by its manufacturer |
| Chassis | Slim-PC (Nettop) with black chassis made of steel Without cooling fan, passive cooling only The bays for memory, 2.5" drive and M.2 card can be easily accessed by removing two cover plates. Dimensions: 200 x 165 x 39.5 mm (LWH) = 1.3 litres Weight: 1.43 kg net and 2.13 kg gross Two holes for Kensington Lock and numerous threaded holes (M3) at both sides of the chassis |
| Operation Position | 1) Vertical: Usually operated in vertical position with the supplied feet (DisplayPort output facing up). 2) VESA-mounted: The device can also be mounted behind an appropriate monitor using the supplied VESA mount kit. Note: From a thermal point of view horizontal operation is permitted, however, there are no rubber feet on the device. The maximum operating temperature is 35 °C then. |
| Operation System | This barebone system comes without operating system. It is compatible with Windows 10 (64-bit) and Linux (64-bit). |
| Processor | Model: Intel Celeron 3865U (ULV) System-on-a-chip architecture (SoC): no chipset required BGA1356 package - directly soldered onto the mainboard Code name: Kaby Lake-U (7th Generation Intel Core) Cores / Threads: 2 / 2 Clock rate: 1.8 GHz L1/L2/L3 Cache: 128 kB / 512 kB / 2048 kB Memory controller: DDR4-2133 Dual Channel (1.2 V) TDP wattage: 15 W maximum Manufacturing process: 14 nm Maximum Tjunction Temperature: 100 °C Supports 64-bit, VT-x (EPT), VT-d, Enhanced SpeedStep, NX bit, AES-NI, SSE 4.1/4.2 Integrated graphics engine |
| Integrated Graphics | Intel HD graphics 610 GPU clock frequency: 300~900 MHz Execution Units (EUs): 12 Three digital audio/video ports support three independent screens: Supports Ultra HD / 4K resolution at 3840 x 2160 Pixels 1) DisplayPort 1.2 [2,7] supports Ultra HD @ 60 Hz 2) 2x HDMI 1.4b supports Ultra HD @ 30 Hz Note: the DisplayPort of DS77U does not support audio output |
| Mainboard / BIOS | Shuttle Mainboard FS77 All capacitors are high quality solid capacitors Supports resume after power failure [6] Supports Wake on LAN (WOL) Supports Power on by RTC Alarm Supports boot from M.2 SSD cards, USB devices and SD card reader AMI BIOS in 8 MByte EEPROM with SPI interface Supports hardware monitoring and watch dog function Supports Unified Extensible Firmware Interface (UEFI) |
| Power Adapter | External 65 W power adapter (fanless) Input: 100~240 V AC, 50/60 Hz, max. 1.6 A Output: 19 V DC, max. 3.42 A, max. 65 W DC Connector: 5.5 / 2.5 mm (outer/inner diameter) |
| Memory support | 2x SO-DIMM slots with 260 pins Supports DDR4-2133 (PC4-17000) SDRAM at 1.2 V Supports Dual Channel mode Supports a maximum of 16 GB per DIMM, maximum total size: 32 GB Supports two unbuffered DIMM modules (no ECC or registered) |
| 2.5 Drive Bay with SATA connector | Supports one Serial ATA hard disk or one SATA SSD drive in 6.35 cm / 2.5" format Device height: max. 12.5 mm Supports Serial-ATA III, 6 Gb/s (600 MB/s) bandwidth Supports Unified Extensible Firmware Interface (UEFI) Note: no Serial ATA cable is required |
| M.2 Slot for SSDs | The M.2 2280 BM slot provides the following interfaces: - PCI-Express Gen. 3.0 X4 with up to 32 Gbps Data Transfer Speed - SATA v3.0 (max. 6 Gbps) It supports M.2 cards with a width of 22 mm and a length of 42, 60 or 80 mm (type 2242, 2260, 2280). Supports M.2 SATA SSDs (with B+M key) and M.2 PCIe SSDs (with M key) |
| Card Reader | Integrated SD card reader Supports SD, SDHC and SDXC memory flash cards Supports booting from SD card |
| Audio | Audio Realtek® ALC 662 High-Definition Audio Two analog audio connectors (3.5 mm) at the back panel: 1) 2 channel line out (headphones) 2) microphone input Digital multi-channel audio output: via HDMI |
| Dual Gigabit LAN | Dual network with two RJ45 ports Used network chips: 1) Intel i211 Ethernet Controller with MAC, PHY and PCIe interface 2) Intel i219LM PHY connected to the MAC of the processor Supports 10 / 100 / 1.000 MBit/s operation Supports WAKE ON LAN (WOL) Supports network boot by Preboot eXecution Environment (PXE) Supports Teaming mode |
| Wireless Network (WLAN) | Built-in M.2-2230-A/E WLAN card and internal antenna Single-Chip 1T1R WLAN Controller Realtek RTL8188EE Supports IEEE 802.11b/g/n, max. 150 Mbps up-/downstream Security: WPA/WPA2(-PSK), WEP 64/128 bit, IEEE 802.11x/i |
| Front Panel connectors | 2x USB 3.0 2x USB 2.0 2x RS232 serial ports (5V / 12V, 1x switchable to RS422 / RS485) covered with black plastic caps SD card reader (supports SD, SDHC, SDXC) Power button Power LED (blue) HDD LED (yellow) |
| Back Panel connectors | DisplayPort 1.2 2x HDMI 1.4b 2x USB 2.0 2x Intel Gigabit LAN (RJ45) Microphone input Audio Line-out (headphones) DC-input connector for external power adapter 4-pin connector "SW2" (2.54 mm pitch) for power button, Clear CMOS and 5 V DC |
| Always-On Jumper | By removing Jumper J9 (please refer to the quick user guide) the system will start unconditionally once power is applied. |
| Scope of Delivery | Multi-language user guide Two metal feet with four screws M3 x 7 VESA mount for 75/100mm standard (two metal brackets) Four thumbscrews M3 x 5 mm (screws together VESA mount and PC) Four screws M4 x 10 mm (to fix the VESA mount to the external surface) Rack (to mount a 2.5" storage in the bay) with two screws M3 x 4 mm Driver DVD for Windows 10 (64-bit) External power adapter with power cord |
| Environmental Specifications | Operating temperature range: 0~40 °C Relative humidity, non-condensing: 10~90 % |
| Conformity & Certifications | EMI: FCC, CE, BSMI, C-Tick Safety: ETL, CB, BSMI Other: RoHS, Energy Star, ErP This device is classed as a technical information equipment (ITE) in class B and is intended for use in living room and office. The CE-mark approves the conformity by the EU directives: (1) 2004/108/EC relating to electromagnetic compatibility (EMC), (2) 2006/95/EC relating to Electrical Equipment designed for use within certain voltage limits (LVD), (3) 2009/125/EC relating to ecodesign requirements for energy-related products (ErP), (4) 1999/5/EC related to Radio and Telecommunications Terminal Equipment (R&TTE) |
