Fanless and silent | Completely fanless, no fan noise at all Passive cooling through convective heat transfer Perfect to be used in noise-sensitive environments Fanless means less dust and thus virtually no maintenance required Notice: Please make sure the system is always operated in upright position using either its stand or the optional VESA mount. Ventilation holes must not be blocked to ensure sufficient cooling. |
Low power consumption | Power consumption: ca. 7.5 W (idle mode) and ca. 15.4 W (full load) (Configuration: 4 GB RAM, 120 GB SSD and Windows 8.1) |
Chassis | Dimensions without stand: 25.2 x 16.2 x 3.85 cm (DxHxW) = 1.57 L Weight: 2.1 kg net, 2.8 kg gross Hole for Kensington Lock at the back panel Optional accessory: 75mm and 100mm VESA mounting kit (PV01) |
Operation System | This system comes without operating system. It is compatible with Windows 8 / 8.1 (64 bit), Windows 7 (64 bit) and Linux (64 bit) |
Processor | Intel Celeron J1900, Quad Core CPU clock frequency: 2.00 GHz, max. Turbo frequency: 2.42 GHz Silvermont architecture, Bay Trail-D platform, 22nm structure CPU cores/Threads: 4/4 Cache: 2 MB Thermal Design Power (TDP): 10W SOC design with integrated graphics processor |
Integrated Graphics | The Graphics Processing Unit (GPU) is integrated into the processor Intel HD Graphics (7th gen), graphics frequency: 688~854 MHz Supports DirectX 11.0, OpenGL 4.0, OpenCL 1.2, HDCP 1.3 (Blu-ray) Execution Units (EU): 4 Three video outputs: - HDMI: max. 1920x1200 resolution @ 60Hz - Display Port: max. 2560x1600 resolution @ 60Hz - D-Sub (VGA): max. 1920x1200 resolution @ 60Hz Dual display: supports max. two independent displays Full hardware acceleration: - for decode: H.264, MPEG2, MVC, VC-1, VP8, MJPEG - for encode: H.264, MPEG2, MVC |
UEFI Firmware | 8Mbit Flash ROM with AMI s Aptio UEFI BIOS Firmware Based on the Unified Extensible Firmware Interface (UEFI) Supports Power fail resume / AC power on state / always on / always off Supports Wake-on-LAN (WOL) from S3, S3, S5 ACPI states Supports boot up from external flash memory cards |
Memory | 1x SO-DIMM slot with 204 pins Supports one module DDR3L-1333 (PC3-10600) at 1.35V Maximum capacity: 8 GB DDR3L-1600 is supported at DDR3L-1333 clock rate Caution: This mainboard does only support 1.35V DDR3L memory modules. Note: DDR3L has a lower operation voltage compared to DDR3 |
Optical drive (optional) | Supports an optical DVD or Blu-ray slim-line drive Serial ATA interface, 12.7 mm height, Slimline SATA connector |
Hard disk drive/SSD (2.5 | Supports one Serial ATA hard disk (5400 / 7200 rpm) or one SATA SSD drive in 6.35cm/2.5" format Serial ATA II Interface with up to 300 MB/s transfer speed Supports a drive with max. 9.5 mm height Supports Unified Extensible Firmware Interface (UEFI) |
Integrated Audio | Realtek ALC269 Audio CWired Networkodec with Azalia and D3 mode support Two analog audio connectors (3.5mm): 1) Line out (head phone) 2) Microphone input |
Card Reader | Integrated card reader supports SD, SDHC and SDXC memory flash cards |
Wired Network | RJ45 connector supports Gigabit LAN at 10/100/1000 Mbit/sec. Network controller Realtek RTL8411 Supports Wake-on-LAN (WOL) from S3, S3, S5 ACPI states |
Wireless Network (WLAN) | Half-size Mini PCIe card with RTL8188EE chip Supports IEEE 802.11b/g/n, max. 150Mbps up-/downstream Security: WPA/WPA2(-PSK), WEP 64/128bit, IEEE 802.11x/i |
Front Panel Connectors | 1x USB 2.0 SD card reader24/7 nonstop operation |
Back Panel Connectors | HDMI digital video and audio output DisplayPort digital video and audio output D-Sub/ VGA analog video output (15 pin) 1x USB 3.0 3x USB 2.0 Gigabit network (LAN, RJ45) Audio Line-out (head phone) Microphone input DC input for the external power adapter Perforation for TV antenna (diameter: 9 mm) |
Internal USB Connectors | Internal USB 2.0 Type-A connector for USB dongle (for e.g. memory stick, 3G stick, DVB-T stick, etc.) Supports boot from internal USB memory stick. |
LEDs and Buttons | Power button Power LED (blue) |
Power Supply | External 40W AC/DC power adapter (fanless), 19V / 2.1A AC Input: 100~240V AC, 50~60Hz Automatic voltage adjust Dimensions: 89.5 x 37 x 26.5 mm (LWH) DC Connector: 5.5/2.5mm (outer/inner diameter) |
Optional Accessories | - VESA mount made of metal (PV01) - Adapter for second 2.5" drive instead of optical drive (PHD2N) |
24/7 nonstop operation | This device is approved for 24/7 permanent operation. Requirements: - Free circulation of air amongst the PC must be guaranteed. - Ventilation holes must be clear. - Any installed hard disk must also be approved for permanent operation by its manufacturer (max. one hard disk) |
Environmental Spec | Operating temperature range: 0~35°C Relative humidity range: 10~90% (non-condensing) |
Certification and Compliance | EMI: CE, FCC, BSMI, C-Tick Safety: CB, BSMI, ETL Other compliances: RoHS, Eup Lot6 This device is classed as a technical information equipment (ITE) in class B and is intended for use in living room and office. The CE-mark approves the conformity by the EU-guidelines: - EMV-guideline 89/336/EWG electromagnetic tolerance - LVD-guideline 73/23/EWG use of electric devices within certain voltage-limits |